git-annex-initremote

git-annex-initremote(1)      General Commands Manual     git-annex-initremote(1)



NAME
       git-annex-initremote - creates a special (non-git) remote

SYNOPSIS
       git annex initremote name type=value [param=value ...]

DESCRIPTION
       Creates a new special remote, and adds it to .git/config.

       Example Amazon S3 remote:

        git annex initremote mys3 type=S3 encryption=hybrid keyid=me@example.com
       datacenter=EU

       Many different types of special remotes are supported by git-annex.  For
       a list and details, see <https://git-
       annex.branchable.com/special_remotes/>

       The remote's configuration is specified by the parameters passed to this
       command. Different types of special remotes need different configuration
       values. The command will prompt for parameters as needed. A few
       parameters that are supported by all special remotes are documented in
       the next section below.

       Once a special remote has been initialized once with this command, other
       clones of the repository can also be set up to access it using git annex
       enableremote.

       The name you provide for the remote can't be one that's been used for any
       other special remote before, because git-annex enableremote uses the name
       to identify which special remote to enable. If some old special remote
       that's no longer used has taken the name you want to reuse, you might
       want to use git annex renameremote.

OPTIONS
       --fast

              When initializing a remote that uses encryption, a cryptographic
              key is created. This requires sufficient entropy. If initremote
              seems to hang or take a long time while generating the key, you
              may want to Ctrl-c it and re-run with --fast, which causes it to
              use a lower-quality source of randomness. (Ie, /dev/urandom
              instead of /dev/random)

COMMON CONFIGURATION PARAMETERS
       encryption

              All special remotes support encryption. You will need to specify
              what encryption, if any, to use.

              If you do not want any encryption, use encryption=none

              To encrypt to a GPG key, use encryption=hybrid keyid=$keyid ...
              and fill in the GPG key id (or an email address associated with a
              GPG key).

              For details about this and other encrpytion settings, see
              <https://git-annex.branchable.com/encryption/>

       autoenable
              To avoid git annex enableremote needing to be run, you can pass
              "autoenable=true". Then when git-annex-init(1) is run in a new
              clone, it will attempt to enable the special remote. Of course,
              this works best when the special remote does not need anything
              special to be done to get it enabled.

       uuid   Normally, git-annex initremote generates a new UUID for the new
              special remote. If you want to, you can specify a UUID for it to
              use, by passing a uuid=whatever parameter. This can be useful in
              some unusual situations.  But if in doubt, don't do this.

SEE ALSO
       git-annex(1)

       git-annex-enableremote(1)

       git-annex-renameremote(1)

AUTHOR
       Joey Hess <id@joeyh.name>

                                                         git-annex-initremote(1)