git-annex-registerurl

git-annex-registerurl(1)    General Commands Manual   git-annex-registerurl(1)



NAME
       git-annex-registerurl - registers an url for a key

SYNOPSIS
       git annex registerurl [key url]

DESCRIPTION
       This plumbing-level command can be used to register urls where a key
       can be downloaded from.

       No verification is performed of the url's contents.

       If no key and url pair are specified on the command line, batch input
       is used, the same as if the --batch option were specified.

       Normally the key is a git-annex formatted key. However, to make it
       easier to use this to add urls, if the key cannot be parsed as a key,
       and is a valid url, an URL key is constructed from the url.

OPTIONS
       --batch

              In batch input mode, lines are read from stdin, and each line
              should contain a key and url, separated by a single space.

       -z     When in batch mode, the input is delimited by nulls instead of
              the usual newlines.

              (Note that for this to be used, you have to explicitly enable
              batch mode with --batch)

SEE ALSO
       git-annex(1)

       git-annex-addurl(1)

AUTHOR
       Joey Hess <id@joeyh.name>

                                                      git-annex-registerurl(1)