GNUCAP(1)                         Debian GNU                         GNUCAP(1)

       gnucap - GNU Circuit Analysis Package

       gnucap [-b filename] [-i filename]

       GNUCAP is a general purpose circuit simulator.  It performs nonlinear
       dc and transient analyses, fourier analysis, and ac analysis linearized
       at an operating point.  It is fully interactive and command driven.  It
       can also be run in batch mode or as a server.  The output is produced
       as it simulates.  Spice compatible models for the MOSFET (level 1,2,3)
       and diode are included in this release.

       Since it is fully interactive, it is possible to make changes and re-
       simulate quickly.  The interactive design makes it well suited to the
       typical iterative design process used it optimizing a circuit design.
       It is also well suited to undergraduate teaching where Spice in batch
       mode can be quite intimidating.  This version, while still officially
       in beta test, should be stable enough for basic undergraduate teaching
       and courses in MOS design, but not for bipolar design.

       In batch mode it is mostly Spice compatible, so it is often possible to
       use the same file for both GNUCAP and Spice.

       The analog simulation is based on traditional nodal analysis with
       iteration by Newton's method and LU decomposition.  An event queue and
       incremental matrix update speed up the solution for large circuits (at
       some expense for small circuits).

       It also has digital devices for mixed signal simulation.  The digital
       devices may be implemented as either analog subcircuits or as true
       digital models.  The simulator will automatically determine which to
       use.  Networks of digital devices are simulated as digital, with no
       conversions to analog between gates.  This results in digital circuits
       being simulated faster than on a typical analog simulator, even with
       behavioral models.  The digital mode is experimental and needs work.
       There will be substantial improvements in future releases.

       Two command-line options are available. Only one of these may be
       specified. If no parameters are given, gnucap will start in interactive

       -b filename
              execute the commands in the named file then exit (batch mode)

       -i filename
              execute the commands in the named file then go into interactive

       See /usr/share/doc/gnucap/bugs for a list of known bugs in this

       GNUCAP is an ongoing research project.  It is being released in a
       preliminary phase in hopes that it will be useful and that others will
       use it as a thrust or base for their research.  I also hope for some
       comments that may help me direct my research.

       GNUCAP is being written by Albert Davis <>

       This manual page was written by Jon Rabone <> and
       maintained by Hamish Moffatt <> for the Debian package
       of gnucap.  For the full LaTeX documentation, please see

Debian Project                   November 2001                       GNUCAP(1)