ladvd

ladvd(8)                    System Manager's Manual                   ladvd(8)



NAME
       ladvd - send link layer advertisements

SYNOPSIS
       ladvd [ -a ] [ INTERFACE ] [ INTERFACE ] ...

DESCRIPTION
       ladvd sends LLDP (Link Layer Discovery Protocol) advertisements on all
       available interfaces. This makes connected hosts visible on managed
       switches. By default it will run as a privilege-separated daemon.
       Additional protocols can be enabled using the -C, -E, -F and -N
       options. Optionally a list of interfaces which ladvd should utilize can
       be supplied.

INTERFACES
       ladvd detects and uses all configured (UP) physical Ethernet interfaces
       by default, wireless interfaces can be enabled via the -w option.
       Additionally ladvd will recognize bundled interfaces (bridges, bonding)
       and use these to transmit additional information. The result is that
       normally it should not be necessary to specify interfaces on the ladvd
       command-line. The only reason for specifying interfaces is to
       explicitly exclude a particular interface.

OPTIONS
       -a     Auto-enable protocols based on received packets (also enables
              receive mode).

       -d     Dump pcap-compatible packets to stdout which can be piped to
              tcpdump (via "| tcpdump -r -") or redirected to a file for
              further analysis.

       -f     Run in the foreground and send logging to stderr.

       -h     Print usage instructions.

       -m address
              Management address for unnumbered interfaces, can be specified
              for IPv4 and IPv6.

       -n     Use management addresses specified via -m for all interfaces.

       -o     Run only once, useful for quick troubleshooting.

       -r     Receive packets, and use them for various features.

       -q     Use each interface's hwaddr the generate the chassis-id TLV. Not
              recommended because the chassis-id should be the same for all
              interfaces.

       -t     Use Tun/Tap interfaces.

       -u user
              Switch to this user (defaults to ladvd)

       -v     Increase logging verbosity.

       -w     Use wireless interfaces.

       -z     Save received peer information in interface descriptions
              (requires SIOCSIFDESCR support). This also enables receive mode.

       -c <CC>
              Specify a two-letter ISO 3166 country code (required for LLDP
              location support).

       -l <location>
              Specify the physical location of the host.

       -C     Enable CDP (Cisco Discovery Protocol).

       -E     Enable EDP (Extreme Discovery Protocol).

       -F     Enable FDP (Foundry Discovery Protocol).

       -N     Enable NDP (Nortel Discovery Protocol) formerly called SynOptics
              Network Management Protocol (SONMP).

AUTHOR
       Sten Spans <sten@blinkenlights.nl>



ladvd                            July 19 2009                         ladvd(8)